Kenwood MGR-E8-B - Manual (Page 52)

MGR-E8 52
Connection of external components
The Line output can be used to connect an external component such as a speaker
with built-in amplifier.
The USB connector can be used to connect an external component such as a stereo
set with USB capability.
Connecting to the Line outout
FM transmitter
Speaker with built-in
amplifier
Cable with stereo mini-plugs
Stereo amplifier
Car stereo
1
Switch this unit ON
2
Connect an external component
Connect it to the [LINE OUT] terminal of this unit.
• Prepare an optimum audio cable (commercially available) according to the input
terminal of the connected external component.
• When using a FM transmitter, noise may be interfered depending the installation
environment, including the vehicle model, devices in the surroundings and the
antenna positioning.
• Do not use or leave this unit or connected component in an automobile
compartment with high temperatures. Otherwise, equipment failure may result.
• During monitoring of the recorded audio through the speaker(s) of the external
component, a howling sound may be produced if the speaker(s) is too close to
the microphone. If this happens, increase the distance between the microphone
and speaker(s) or reduce the speaker monitoring volume.
B60-5825-08_00_MGR-E8(E)_English_1AJ6P1P0109--(XE0).indd 52 B60-5825-08_00_MGR-E8(E)_English_1AJ6P1P0109--(XE0).indd 52 10/08/04 13:48 10/08/04 13:48