ATEN CS-1754 - Manual (Page 36)

CS-1754 / CS-1758 User Manual
28
(Continued from previous page.)
Setting Function
PORT ID
DISPLAY
MODE Selects how the Port ID is displayed: the Port Number alone
(PORT NUMBER); the Port Name alone (PORT NAME); or the
Port Number plus the Port Name (PORT NUMBER + PORT
NAME). The default is PORT NUMBER + PORT NAME).
SCAN
DURATION Determines how long the focus dwells on each port as it cycles
through the selected ports in Auto Scan Mode (see F7 SCAN,
page 32). Key in a value from 1 - 255 seconds, then press [Enter].
Default is 5 seconds; a setting of 0 disables the Scan function.
SCAN/SKIP
MODE Selects which computers will be accessed under Auto Scan Mode
(see F7 SCAN, page 32). Choices are:
ALL - All the Ports which have been set Accessible (see SET
ACCESSIBLE PORTS, page 31);
POWERED ON - Only those Ports which have been set Accessible
and are Powered On;
QUICK VIEW - Only those Ports which have been set Accessible
and have been selected as Quick View Ports (see SET QUICK
VIEW PORTS, page 31);
QUICK VIEW + POWERED ON - Only those Ports which have
been set Accessible and have been selected as Quick View Ports
and are Powered On. The default is ALL.
Note: The Quick View choices only show up on the administrator's
screen, since only the administrator has Quick View setting rights
(see SET QUICK VIEW PORTS, page 31, for details).
SCREEN
BLANKER If there is no input from the console for the amount of time set with
this function, the screen is blanked. Key in a value from
1 - 30 minutes, then press [Enter]. A setting of 0 disables this
function. The default is 0 (disabled).
HOTKEY
COMMAND
MODE Enables / Disables the Hotkey function (see Hotkey Operation,
page 35) in case there is a conflict with programs running on the
computers. On enables the function, Off disables it. The default is
On.
cs1754-1758.book Page 28 Friday, July 20, 2007 10:06 AM