Burr King BK75 - Manual (Page 14)

Cabinet Dust Collector, Series 50 to 80
13
Outdoor Exhaust Deflector
1. Remove the top door assembly and set aside.
2. Place a piece of non-combustible cloth over the
filters in the clean-air chamber to protect them
from drilling chips.
3. Use a .218-in diameter drill bit to drill eight
holes as shown.
4. Position the indoor exhaust deflector on the
cabinet top, align holes and fasten using eight
#10-24 x 1/2-in bolts, washers, and nuts
supplied. Tighten securely.
5. Apply sealant around outside edge of the
exhaust deflector.
6. Carefully remove the cloth protecting the
filters. Replace the top door assembly and
tighten securely by hand.
Outdoor Exhaust Deflector
3.25
3.25
3.25
7.31
.218
8x
2.37
8.94
sealant
10-24 x 1/2-in
slot-head screw
#10 flat washer
10-24 hex nut