AMICA OKF621G EN - Manual (Page 10)

10
MAINTENANCE
8. Fix the carbon filter (which must be purchased separately) to the inside frame of
the ventilation hood body (which is accessible only after the air filter/-s is/are remo-
ved). When buying an air filter, information on the type of the ventilation hood must
be provided to the seller. The information can be found on the rating plate.
The rating plate can be
found inside the hood.
6. Take off the protective film from the chimney masking elements.
7. Set the length of the upper masking element as required and fix it to the grip with
two side screws (item A1 below).
A1
9. Re-install the fat filter (the number of filters depends on the type of ventilation
hood).
10. Connect the ventilation hood to the power supply network.
Control panel
The operation of the ventilation hood is controlled by a combined switch that can
be found on the front of the ventilation hood body.
- the „ ” switch controls the light – turns the light on and off,
- the „ ” switch sets the motor in the third gear,
- the „ ” switch sets the motor in the second gear,
- the „ ” switch sent the motor in the first gear,
- the „ ” switch turns of the motor of the ventilation hood.
Caution!
Never press two or more buttons at once.