AMICA OKF621G EN - Manual (Page 8)

8
INSTALLATION
5. Put the air outlet pipe into the connection port of the air outlet at the ventilation
hood body and fix it with 3 small screws (the pipe and the screws are supplied). The
other end of the pipe (marked HL) connect with the ventilation channel.
6. Install the grip of the upper chimney masking element in the axis of symmetry of
the ventilation hood (over the ventilation duct).
GOOD BAD
9. Re-install the fat filter (the number of filters depends on the type of ventilation
hood).
10. Connect the ventilation hood to the power supply network.
7. Take off the protective film from the chimney masking elements.
8. Set the length of the upper masking element as required and fix it to the grip with
two side screws (item A1 below).
A1