Wagner ProCoat 9185G - Manual (Page 4)

English 4
What’s in
the box?*
Start
*Certain parts of the sprayer will not be
assembled out of the box. Be sure to read
Assembly instructions, page 6.
Notice:
Refer to the engine manufacturer’s
instruction manual for complete engine
information. Heed all cautions and
warnings.
Note: The engine on the sprayer will come
filled with oil. However, it is still a good idea
to check it prior to startup. The engine has
sufficient oil when you can see it just below the
opening in the oil reservoir when the oil cap (a)
is removed.
(a)
GS-07 Spray Gun Assembly Sprayer Assembly
VersaTip™ Spray Tip Assembly
Spray Hose Assembly (50 ft)
Sureflo™ valve
Pail bracket
Suction tube
Material
return tube
Inlet filter
Spray hose port
(reverse side)
DirectLink™ pressure
control knob
AutoOiler™ cap
Hose wrap
Engine
Pump cleaning
adapter
AutoOiler™
button PRIME/SPRAY
knob
Cart knob (2)
Grounding
cable
Shutoff switch
Spray
guard
Spray tip
1. Make sure the gas tank is full.
Move the choke lever (a) up to
the full choke position.
2. Push the rubber prime button
(b) 7-10 times.
3. Pull the starter rope (c) rapidly
and firmly. Continue to hold
the rope as you let it return.
Pull and return the rope until
the engine starts.
4. Once the engine is running,
slowly move the choke
lever (d) down to the closed
position.
Starting the engine:
Follow these steps to start the
engine when it is “cold”, or has
not been recently running.
If the engine is “warm”, follow
step 3 only.
ImPORTANT: Do not pull starter
cord to full extension. Doing
so may result in damage to
the engine recoil, and is not
necessary to start this engine.
(a)
1
(b)
2
(c)
3
(d)
4