Getting material to flow, 9 getting material to flow, You will need – Wagner ProCoat 9185G User Manual
Page 9: Start, Spray
You will need:
• Waste bucket
• Scrap material / cardboard
• Drop cloths to protect floors and
furnishings from overspray
ImPOR´TANT: When placed on a smooth
surface, the vibration of the running engine
may cause the unit to move forward or
backward slightly. Avoid placing the unit on
an inclinded surface or near a drop-off such
as stairs. Block the wheels to prevent the
unit from moving.
English
9
3. Getting
Material to
Flow
Start
1. Start the engine (see page
4). Point the spray gun into
a separate waste container.
Unlock the spray gun trigger.
Squeeze and hold trigger
for steps 2-3.
3. Continue to squeeze
trigger until the material
is flowing freely through
the spray gun.
4. Peform the Pressure
page 7.
2. Turn the PRIME/SPRAY
knob to SPRAY.
5. Thread the spray tip guard
assembly onto the gun.
Tighten by hand.
6. Rotate spray tip forward to one of the
SPRAY positions.
Unlock the spray gun trigger.
7. Start the engine (see
directions on page 4).
Turn the PRIME/SPRAY
knob to SPRAY.
8. Point the spray gun at a piece of
scrap material/cardboard.
Pull the trigger and practice spraying
(see pages 10-11).
1
3
4
SPRAY
PR
IM
E
2
SPRAY
PR
IM
E
5
6
7
8
SPRAY
OR
SPRAY
PR
IM
E