Wagner ProCoat 9185G - Manual (Page 8)

English 8
2. Load
Material
Start You will need:
• The material you plan to spray
• Flat blade screwdriver
• Piston Oil™
• Waste bucket
1. Remove AutoOiler cap with a
flat blade screwdriver.
Squirt Piston Oil into the
AutoOiler. Replace cap.
2. Push AutoOiler button 2-5 times
to lubricate the fluid section.
Press button 2-3 times before
every use. Be sure to check
reservoir level (a) and refill as
necessary.
5. Turn the PRIME/SPRAY
knob to PRIME.
4. Place a full container
of spraying material
underneath the suction
tube (a).
Hold the return tube into a
waste container (b).
6. Attach the supplied
grounding wire to a
grounded object.
Start the engine (see
directions on page 4).
7. Increase the pressure to
maximum (+).
Allow pump to run until
you see spray material
flowing from the return
tube.
8. Shut the engine off. Place
return tube back into
material container and clip
return tube and suction tube
together.
3. Fully depress the Sureflo valve
to make sure the inlet ball is
free.
(a)
1 2 3
SPRAY
PR
IM
E
5 4 6 7 8
(a)
(b)