Aalborg XFM Digital - Manual (Page 38)

35
UAR
T
Error Codes:
1
-
Not Supported Command or Back Door is not enabled.
2
-
Wrong # of Arguments.
3
-
Address is Out of Range (MR or MW commands).
4
-
Wrong # of the characters in the Argument.
5
-
Attempt to Alter Write Protected Area in the EEPROM.
6
-
Proper Command or Argument is not found.
7
-
Wrong value of the Argument.
8
-
Reser
ved.
9
-
Manufacture specific info EE KEY (wrong key or key is disabled).
COMMAND
NAME
DESCRIPTION
No.
COMMAND SYNT
A
X
Command
Argument 1
Argument 2
Argument 3
Argument 4
Response
Maintenance Ti
m
er
Hours since last time unit was calibrated.
11
C
R
(read timer)
<V
alue> (in Hours)
C
(set timer to zero)
CC
Full Scale
Returns the full scale rated flow in L/min. (Note: This term is not multiplied by the current K factor)
12
E
<V
alue>
(in L/min)
LCD Back Light
LCD Back Light control (0-100.0%) 0
- off
100
- Maximum Intensity
13
B
0 to 100%
B:<Counts> where: Counts (0 – 4095) B:<V
alue>
where: V
alue (0 – 100.0)
No Argument <Current settings>
Read EEPROM Memor
y
Reads the value in the specified memor
y location.
14
MR
0000 to999 (T
able Index)
<value>
Write EEPROM Memor
y
Writes the specified value to the specified memor
y location. Use
Carefully
, can cause unit to
malfunction. (Note: Some addresses are write protected!)
15
MW
0000 to 999 (T
able Index)
V
alue
MW
,XXX,<V
alue>
where: XXX=T
able Index