Wrong right – ROHM KFD-N - Draw-down power chucks User Manual

Page 10

Advertising
background image

10

2. Important notes

1. The maximum speed may only be used if the chuck is

equipped with a set of reversible jaws (UB) supplied
with the chuck as standard equipment and with the
maximum actuating force applied.

2. At high speeds, the chuck may only be used with an

adequately dimensioned protective hood.

3. Soft top jaws or special jaws, if used, should be as

light as possible.

4. Performance (piston movement ad actuating

pressure) should be monitored in accordance with the
requirements of the Employers’ Liability Assurance
Association.

5. In other respects, we refer you to DIN EN 1550

(European standard), ”Safety requirements for the
configuration and design of rotary chucks”.

Wrong

Right

Examples of dangerous chucking situations and their
remedy

When chucking the workpiece, certain criteria must be taken
in account.
Incorrect chucking can give rise to danger of injury due to work-
pieces flying off the equipment at high speed, or breakage of
the jaws.

If cutting interrupted, reduse feed and cutting depth.

The illustrated examples do not cover all possible danger
situations. It is the responsibility of the user to recognize
possible
sources of danger and to adopt the necessary measures.

Despite all precautionary measures, an element of risk
cannot be excluded.

Tightening torques in Nm:

Class

M5

M6

M8

M10

M12

M14

M16

M18

M20

M22

M24

8.8

5,5

9,5

23

46

80

130

190

270

380

510

670

Nm

10.9

8,1

13

33

65

110

180

270

380

530

720

960

Nm

12.9

9,5

16

39

78

140

220

330

450

640

860

1120

Nm

15. When screws are replaced or loosened, defective

replacements or inadequate fastening may cause
personal injuries and material damage.
Unless specified otherwise, all fastening screws must
be tightened to the torques recommended by the screw
manufacturer for the relevant strendth class.
All fastening screws, which account of their application,
must be frequently loosened and retightened, in con-
junction with resetting work for example, must be coated
with antiseize (grease paste) in the thread area and on
the head contact surface at intervals of 6 months.
When replacing the original screws, make sure that the
replacements have the same strength class (normally
12.9). The tightening torques for sizes M5-M24, classes
8.8, 10.9 and 12.9, are listed in the table at the top of
this page.

16. Always use class 12.9 for screw fastening clamping

inserts, top jaws, stationary locators, cylinder covers and
similar elements.

17. The manufacturer undertakes no responsibility for

spares other than original RÖHM parts. To eliminate
doubts and assure correct performance of the order,
state the 6-digit identification number engraved in the
assembly when ordering spares or individual parts.
However, in many casas the item number stated in the
assemply drawing or parts list and a good description of
the component may be sufficient information for filling
your order.

Support workpiece between
centres or using a stady

Use a larger chuck

Support between centres,
extend chucking step

Chuck using greatest possible
chucking diameter

Chuck using self-aligning
inserts

Projecting length of mounted
workpiece too great relative to
chucked length.

Chucking diameter too
great.

Workpiece too heavy,
chucking step too short.

Chucking diameter too
small

Workpiece has a casting
or forging-related taper

09241-k001-001 29.04.2004 14:52 Uhr Seite 10

Advertising