ACR Electronics Nauticast Y1-03-0211 User Manual
Page 6
Y1-03-0211 Rev D
2
1.2
Entering the MMSI / IMO / DAC / ESN Numbers
Select from the Main Menu
“Service Configuration” Number 6. The default password from
the factory is mentioned on your AIS display at the protection foil. (see Appendix 7.3 for
password information). Enter Service Password and use the up and down arrows on keypad
to select “Change MMSI / IMO” than press M5 “Select” or “by pressing number 3 on the
keypad.
Input your MMSI and IMO number and press Save to store data. Unit will reboot itself after
pressing Save. Continue to 4.2 after reboot, if no IMO number is available use the value 0
(Zero).
Service Configuration Menu Example:
NOTE: MMSI and IMO Data input are limited to 9 characters.
N 1
o
19' E 0
o
13' |1>0.01|2>1.30|3>1.80nm
|----------------------------------
| Menu
-----| |
| +- 1. Messages
View | +- 2. AIS Status
| +- 3. Voyage Settings
-----| +- 4. Ship Settings
| +- 5. Transponder Configuration
Msg. | +- 6. Service Configuration
| +- 7. Display Settings
-----| +- 8. Graphical Display Settings
|
Displ|
----------------------------------------
NUM|Select->| | |<-Back
N 1
o
21' E 0
o
14' |1>0.01|2>1.30|3>1.80nm
|----------------------------------
| 6. Service Configuration
-----| |
| +- 1. Change Service Password
View | +- 2. User Password Settings
| +- 3. Change MMSI / IMO
-----| +- 4. Change DAC / ESN
| +- 5. Change AIS Mode
Msg. | +- 6. Restore Factory Settings
|
-----|
|
Displ|
----------------------------------------
NUM| Select->| | |<-Back