PHASE RESEARCH 2000 Series - Manual (Page 26)

SECTION 2 - OPERATION 2-9
PHASE RESEARCH
USER GUIDE
SECTION 2 - OPERATION
2-7 Thermal Printer
The Thermal Printer prints reports and logs significant events that occur during the Timer’s
operation, both automatically as scheduled and manually as desired.
The printer uses special thermal paper tape, designed to print only on the side facing out on the
roll. The serrated edge of the paper exit slot helps you to neatly tear off reports.
When the paper tape’s edges begin to turn pink, it is time to load a new roll. To do so:
PRINTER
RESET
BUTTON
PAPER ROLL
HOLDER
POINT
LOADING PROCEDURE:
1
2
3
4
5
6
1
2
3
4
Open printer door.
Place roll in holder so that printed instructions
face you upside down.
Cut paper so that it comes to a point as shown.
Insert point of paper into top of printer until
point comes through front.
Carefully pull point of paper directly toward top
of unit until about 6 inches is fed through.
Feed paper completely through printer door
and close and secure door.
Carefully cut paper where it enters printer.
Taking care not to put stress on printer parts,
pull remaining paper from front of printer. Pull
Toward top of unit.
USE ANY DEVICE (SCISSORS,
SCREWDRIVER, POINTED OBJECT) TO
REMOVE PAPER.
Reset printer by pressing the PRINTER
RESET BUTTON. Printhead will cycle
back and forth.
Repeat the loading procedure.
CUT PAPER - DO NOT FOLD
DO NOT
IF PAPER JAMS:
TO RESET PRINTER:
1 The printer has a safety shutoff feature to
protect the printer from heat damage.
Reset printer by pressing the PRINTER
RESET BUTTON. Printhead will cycle
back and forth.
IMPORTANT:
OPERATOR-CAUSED DAMAGE TO THE PRINTER OR MISUSE WILL VOID THE WARRANTY. TAKE CARE WHEN
REMOVING PAPER JAMS, LOADING PAPER, ETC., TO FOLLOW ALL DIRECTIONS (BELOW) TO AVOID MISUSE
OR OTHERWISE HARM THE PRINTER.