AMX Mio Modero R-3 - Manual (Page 11)

Setup Mode
7 Mio Modero R-3 Remote
Setup Mode
Overview
The Setup mode allows you to set the following device features on the Mio R-3:
 Transmit Mode
 Timeout Adjustment
 Download Mode
 Debug Mode
 Firmware Version
 Device ID
 LED Awake Brightness
 LED Sleep Brightness
 ZigBee Pan ID, Channel, and System Connection
 Network Scan
To enter Setup mode:
1. Press and hold the STOP button and the INPUT button. The two buttons must be pressed within 0.1
seconds of each other and held down for 2 seconds. The device indicates you are now in Setup mode. The
available modes are listed below.
2. Press the EXIT key when you are finished. The Mio R-3 will automatically exit Setup mode after 30
seconds unless the device is in Download mode.
Transmit Mode
Press button 1 to select from one of the different available transmission modes. The Transmit mode changes
each time 1 is pressed. The predetermined modes are:
 IR 38 Khz
 IR 455 Khz
 ZigBee Mode
 IR 38 + ZigBee
 IR 455 + ZigBee
The display indicates the selected mode. 30 seconds after selecting the mode, the menu returns to Setup mode.
Timeout Adjustment
Press button 2 on the remote to change the sleep timeout from the default. Each time 2 is pressed, the sleep
timeout raises incrementally. The predetermined sleep timeouts are 3,6,9, and 12 seconds.
The display indicates the selected sleep timeout. 30 seconds after selecting the mode, the menu returns to
Setup mode.
Download Mode
In order to download new firmware or a new configuration or font file to the Mio R-3 remote using the
remote's program port (see Using the Programming Jack on The Mio R-3 section on page 11 for details), the
remote must first be placed into Download mode. Press 3 on the remote to toggle the Download mode OFF
and ON. The Download mode must be ON before you can download a file to the Mio R-3 device. While the
Download mode is ON, the device will not go to sleep. Once the download is complete, this setting must be
returned to Download Off. A firmware download will cause the remote to reset and this will automatically
reset the remote to Download Off.
To leave Download mode, press the EXIT button.
Your settings will not be lost in the event of battery removal or failure.