AMX Mio Modero R-3 - Manual (Page 13)

Setup Mode
9 Mio Modero R-3 Remote
ZigBee Extended PAN ID, Channel, and System Connection
Pressing the 9 button will display the current ZigBee Extended Personal Area Network (PAN) ID and channel
for the device. (For more information on ZigBee Personal Area Networks, refer to the NXR-ZGW/-ZRP-PRO
Operation/Reference Guide, available from www.amx.com.) In order to display the NetLinx Master IP and
ZigBee gateway EUI addresses, press the Move Up arrow on the scroll wheel to scroll up. and pressing the
Move Down arrow will scroll down. When finished, press Exit to save the Extended PAN ID and channel
information and leave Setup mode. The display will return to Setup mode 30 seconds after releasing the 9
button.
Network Scan
Pressing the 0 button makes the Mio R-3 scan all frequencies and store all active Extended PAN IDs and
Channels in memory. The display will show the first accessible Extended PAN ID and Channel.
To display other Extended PAN IDs and Channels found in the area, press the Move Up or Move Down
arrows on the scroll wheel until the remote displays the desired Extended PAN ID and Channel.
To connect to a particular Extended PAN ID, pressing the center button on the scroll wheel will initiate the
remote to connect to a network.
If no ZigBee networks were found, the display will read SCAN FAIL before returning to Setup mode. To exit
the Network Scan, press the Exit button.
TeleText Mode
For various reasons, the standard numeric keypad for the Mio R-3 may be bypassed in favor of using the
TeleText mode. This mode allows the central toggle wheel to be used to enter alphanumeric information, such
as passwords, much like the toggle wheel on a phone.
Pressing the Input button puts the central toggle wheel into TeleText mode. Press Input again to leave
TeleText mode.
TeleText button functions
Toggle Wheel up/down Scrolls character up/down
Toggle Wheel left/right Moves cursor left/right between
Last button Backspace (moves cursor back one space and erases previous character)
Exit button Abort (erases previously selected information without entering it)
Enter button Done (submits information)
When upgrading a ZigBee network from ZigBee to ZigBee Pro, the firmware upgrade
necessary for ZigBee Pro will leave the Mio R-3 in a default TeleText mode. This may
be left at any time by pressing the Input button.