AMX Mio Modero R-3 - Manual (Page 17)

Programming The Mio R-3
13 Mio Modero R-3 Remote
Channel Codes
The following table gives the channel codes associated with each button on the Mio R-3. Thirty-six of the
buttons change channel codes based on what button was last pressed. Nine of the buttons always emit the same
channel code regardless of what button was last pressed.
The Mio R3 also works in "single device mode," configurable by setting the mode to dynamic and the number
of devices to 1 (see the Send_Commands section on page 19). That is, it always emits the same channel for the
buttons. Code on the NetLinx master can interpret and re-map the channel depending on what device mode the
Mio R3 is in, from selecting Device 1 - Device 6, or a combination for extra devices.
Channel Codes
Button Dev 1 Dev 2 Dev 3 Dev 4 Dev 5 Dev 6
PLAY q 1 41 81 121 161 201
STOP w 2 42 82 122 162 202
PAUSE e 3 43 83 123 163 203
FFW t 4 44 84 124 164 204
REW i 5 45 85 125 165 205
S.FFD y 6 46 86 126 166 206
S.REV u 7 47 87 127 167 207
REC p 8 48 88 128 168 208
Power Symbol 9 49 89 129 169 209
0 10 50 90 130 170 210
1 11 51 91 131 171 211
2 12 52 92 132 172 212
3 13 53 93 133 173 213
4 14 54 94 134 174 214
5 15 55 95 135 175 215
6 16 56 96 136 176 216
7 17 57 97 137 177 217
8 18 58 98 138 178 218
9 19 59 99 139 179 219
ENTER 21 61 101 141 181 221
CH+ 22 62 102 142 182 222
CH- 23 63 103 143 183 223
VOL + 24 64 104 144 184 224
VOL - 25 65 105 145 185 225
MUTE 26 66 106 146 186 226
INPUT 29 69 109 149 189 229
MENU 31 71 111 151 191 231
Up 32 72 112 152 192 232
Down 33 73 113 153 193 233
Left 34 74 114 154 194 234
Right 35 75 115 155 195 235
SELECT 36 76 116 156 196 236
EXIT 37 77 117 157 197 237
GUIDE 38 78 118 158 198 238