Campbell Scientific TX312 High Data Rate GOES Transmitter - Manual (Page 57)

Appendix D. RAWS-7 Data Format
D-9
; Calculate average wind speed and direction
37: Wind Vector (P69)
1: 1
Reps
2: 0 Samples per Sub-Interval
3: 1 S, é1 Polar
4: 5 Wind Speed/East Loc [ Wspd ]
5: 6 Wind Direction/North Loc [ Wdir ]
; Calculate and hold hourly Max Wspd and Wdir in input
; locations 12 and 13 (MaxHrWS, MaxHrWD)
38: If time is (P92)
1: 0
Minutes (Seconds --) into a
2: 60 Interval (same units as above)
3: 10 Set Output Flag High (Flag 0)
; Direct output processing to input locations
39: Set Active Storage Area (P80)
1: 3
Input Storage Area
2: 12 Loc [ MaxHrWS ]
40: Maximum (P73)
1: 1
Reps
2: 0 Value Only
3: 5 Loc [ Wspd ]
41: Sample on Max or Min (P79)
1: 1
Reps
2: 6 Loc [ Wdir ]
; Write hourly RAWS-7 data to final storage area 1.
; Order is important, First in - First out.
;Precip
(Hourly Total)
;Wind Speed (10 minute Average prior to the hour)
;Wind Direction (10 minute Average prior to the hour)
;Air Temperature(Hourly Sample)
;Fuel Temperature
(Hourly Sample)
;RH (Hourly Sample)
;Battery Voltage (Hourly Minimum)
42: If time is (P92)
1: 0
Minutes (Seconds --) into a
2: 60 Interval (same units as above)
3: 10 Set Output Flag High (Flag 0)
; Direct output processing to final storage area 1
43: Set Active Storage Area (P80)
1: 1
Final Storage Area 1
2: 60 Array ID
44: Totalize (P72)
1: 1
Reps
2: 8 Loc [ Prcip ]