Asus Motherboard DSBF-DE/SAS - Manual (Page 49)

ASUS DSBF-DE Series -
3. USB device wake-up (3-pin USBPW12, USBPW34)
Set these jumpers to +5V to wake up the computer from S1 sleep mode (CPU
stopped, DRAM refreshed, system running in low power mode) using the
connected USB devices. Set to +5VSB to wake up from S4 sleep mode (no
power to CPU, DRAM, power supply in reduced power mode).
• The USB device wake-up feature requires a power supply that can provide
500mA on the +5VSB lead for each USB port; otherwise, the system will
not power up.
• If you are using Windows ® 2000, you need to install Service Pack 4 to wake
up the system from S4 sleep mode.
• The total current consumed must NOT exceed the power supply capability
(+5VSB) whether under normal condition or in sleep mode.
2. LAN controller setting (3-pin LAN_EN1)
This jumper allows you to enable or disable the onboard Intel ® 6321 Gigabit
LAN controller. Set to pins 1-2 to activate the Gigabit LAN feature.
®
DSBF-DE Series LAN1_EN setting
LAN1_EN1
Enable
(Default)
Disable
3 2 2 1
®
DSBF-DE Series USB device wake up
USBPW12
(Default)
+5V +5VSB
3 2 2 1
USBPW34
(Default)
+5V +5VSB
3 2 2 1