Alpine F1 STATUS PXI-H990 - Manual (Page 94)

Using the multi-channel function
90
- EN
TITLE
6.1-Channel
Settings (6.1CH
MODE)
PCM Output
Settings (PCM OUT
MODE)
Description
The operations performed with the remote control unit in
step 1 can also be performed by pressing and holding
MENU (SETUP)
for at least 3 seconds, moving the joystick
up or down to select “AP SETUP”, then pressing the joystick.
When the speaker is set to “OFF” mode, audio is not
produced from that speaker. See “Setting the speakers”,
(page 7) and “Speaker setup”, (page 53).
Once the settings are made, we recommend storing them in
the memory. See page 93 for instructions.
The operations performed with the remote control unit in
step 1 can also be performed by pressing and holding
MENU (SETUP)
for at least 3 seconds, moving the joystick
up or down to select “AP SETUP”, then pressing the joystick.
When a speaker is set to the “OFF” mode, no sound is
output from that speaker. See “Setting the speakers” (page
7).
The “DOLBY PROLOGIC II” and “DTS Neo:6” settings are
only valid for 2-channel audio signals (including PCM and
bit stream).
Once the settings are made, we recommend storing them in
the memory. See page 93 for instructions.
When playing back 96kHz or 192kHz DVD-Audio when
DOLBY PRO LOGIC II or DTS Neo:6 mode is selected, the
audio signal is automatically down sampled to 48 kHz and
played back.
When “PL II MUSIC” is selected
This adjustment, there is no effect from CENTER WIDTH. If
the center speaker is set to “OFF” in the speaker setup
settings.
“ BI PHANTOM” is turned off when “CENTER WIDTH” is
enabled.
Related page
Supplementary
information This page includes supplementary information for pages 52 to 87.
Please refer to these pages.
Page 77
Page 77
Page 80
Page 80
Page 80
Page 80
Page 83
Page 83
Page 82
Page 77