Samsung SC-DC165-XAA - Manual (Page 119)

ENGLISH
119
Troubleshooting
 If these instructions do not solve your problem, contact your
nearest Samsung authorized service center.
Symptom Explanation/Solution
You cannot switch the
DVD Camcorder on.
 Check the Battery Pack or the AC Power
adapter.
The DVD
Camcorder shuts off
automatically.
 You have left the DVD Camcorder set to
STBY for more than 5 minutes without
using it. To turn on the DVD Camcorder,
press the [Start/Stop] button.
 The Battery Pack is fully exhausted.
Replace it with a fully charged battery pack.
Charge runs out
quickly.
 The atmospheric temperature is too low.
 The Battery Pack has not been charged fully.
 The Battery Pack is completely dead, and
cannot be recharged, use another Battery Pack.
A vertical strip
appears on the screen
when recording a dark
background.
 The contrast between the subject and
the background is too great for the DVD
Camcorder to operate normally. Make the
background bright to reduce the contrast
or use the BLC function while you are
recording in bright Surroundings.
The image in the
Viewfinder is blurred.
 The Viewfinder lens has not been adjusted.
 Adjust the Viewfinder control lever until
the indicators displayed on the Viewfinder
come into sharp focus.
Auto focus does not
work.
 Check the Manual Focus menu.
 Auto focus does not work in the Manual
Focus mode.
When the power is
turned off and then
turned on, a blue
screen appears instead
of the normal screen.
 If the DC Adapter is connected, remove
the cord, turn on the Power switch, and
then connect it again. If the battery is
connected, disconnect it, turn the Power
switch to on, and then connect it again.
臺 灣
故障排除

 若這些指示不能解決問題，請就近與三星授權的維修中心聯絡。
狀況 說明/解決方案
您無法啟動 DVD 攝
錄放影機。

 檢查電池組或交流電源適配器。
DVD 攝錄放影機自
動關閉。

 您將 DVD 攝錄放影機設定為 STBY 超過
5 分鐘而沒有使用它。 若要開啟 DVD 攝
錄放影機，按下 [Start/Stop] 按鈕。

 電池組已完全耗盡電力。 換上充滿電的電
池。
電池電量很快耗盡。

 氣溫太低。


 電池組並未完全充電。


 電池組已完全損毀，並且無法重新充電，
請使用其他的電池組。
在昏暗的背景中錄製
時，螢幕上將會出現
垂直條紋。

 主體與背景之間的對比度太大，DVD 攝錄
放影機無法正常操作。當您在明亮的環境
中錄製時，加亮背景以降低對比度或使用
BLC（背光補償）功能。
觀景窗中的影像模
糊。

 觀景窗鏡頭尚未調整。


 調整觀景窗控制桿直到觀景窗中的指示器
出現清晰的對焦。
自動對焦無法操作。

 檢查手動對焦選單。


 自動對焦無法在手動對焦模式中操作。
關閉電源然後再開啟
時將出現藍色螢幕，
而不是正常螢幕。

 如果已連接交流電變壓器，請先取下連接
線，開啟電源開關，然後再次連接。
如果已連接電池，先取下接線，開啟電源
開關，然後再次連接。