Samsung RF4289HARS-XAA - Manual (Page 7)

setting up _07
01
SETTING
u
P
AccESSORIES AND REquIRED
TOOLS
The following accessories are included with your
refigerator:
Hex wrench Fastener
compression
fitting
compression
nut
Required Tools (Not provided)
You need the following tools to complete the
installation of your refirgerator:
Philips screwdriver (+)
Flat-blade screwdriver
(-)
Socket wrench
(10mm)
Pliers Allen wrench (3/16”) (5mm)
REMOVING THE REFRIGERATOR
DOORS
Some installations require door removal to transport
the refrigerator to its final location.
Do not remove the door/drawer if you don't need to.
If you do not need to remove the refrigerator doors, go
to Adjusting the Level on page 8.
If you need to remove the doors. continue below.
Before removing the door/drawer, make sure you read
the following items:
Disconnect power to the refrigerator before
removing the door or drawer.
• Be careful not to drop, damage or scratch
the door/drawer while removing them.
• Be careful not to get injured while removing the
door/drawer.
• Reattach the door/drawer properly to avoid:
- Moisture from air leakage.
- Uneven door alignment.
- Wasting energy due to improper door seal.
Disassemble the refrigerator doors
Be careful not to drop and scratch the doors
while removing the doors.
Disassemble the refrigerator doors
1. With the door opened, remove the cap top table
( 1 ) with a flat-blade screwdriver (-), and close the
door.
Remove the 3 screws holding down the top table
(
2 ) and turn it with several wires connected.
2. Disconnect one connector ( 3 ) on the right side
door and one connector ( 4 ) on the left side door.
Remove the water line ( 5 ) while pressing the dark
gray color part ( 6 ) of the water line coupler.
If a red clip is on the coupler, it must be
removed before removing the tube.
WARNING cAuTION
WARNING
1
2
4
5
6
3 Red clip
(1/4")
DA68-02520A(0.0)-EN.indd 7 2011.3.2 8:38:32 AM