Samsung NP-Q1-V000-SEA - Manual (Page 178)

178
Q
When I connect a projector, and change the settings to display the screen
image on both the LCD and the projector by pressing the Menu button, the
screen is not displayed properly.
A Click the Menu button, select LCD/CRT and then select Clone. If the screen image
or some part of it is not displayed on the screen, this is because the LCD resolution
is low or the current resolution is too wide and cannot be supported by the projec-
tor. Press the Auto Scaler button and change the resolution to 800x600 pixels.
Q
The shortcut icons are not displayed on the screen.
A The shortcut icons only appear when both the Magic Keyboard and Samsung Dis-
play Manager programs are installed.
Q
When I connect an external monitor and select the monitor, no screen image
is displayed (Clone Mode).
A This may happen when the current resolution is inappropriate or Dual View (Ex-
tended Mode) is selected. Try the following methods.
 When the current resolution is inappropriate
This computer supports the 800x480 WVGA resolution. Since this resolution is
lower than that of the operating system, the above symptom may appear when the
external monitor cannot support this resolution. Change the resolution to 800x600
pixels, click Menu and then select Clone.
 When Dual View (Extended mode) is selected
When Dual View is selected, the Clone Mode is not supported. In this case, un-
select the Dual View, press the Menu button to select the Clone Mode.