Intentional emitter per fcc part 15 – Samsung NP-Q1-V000-SEA User Manual

Page 27

Advertising
background image

27

This equipment has been tested and

found to comply with the limits for a

Class B digital device pursuant to Part

15 of the FCC Rules. These limits are

designed to provide reasonable pro-

tection against harmful interference in

a residential installation. This equip-

ment generate uses and can radiate

radio frequency energy and if not

installed and used in accordance with

the instructions may cause harmful

interference will not occur in a particu-

lar installation. If this equipment does

cause harmful interference to radio

or television reception, which can be

determined by turning the equipment

off and on, the user is encouraged to

try to correct the interference by one or

more of the following measures:
■ Reorient or relocate the receiving

antenna.

■ Increase the separation between the

equipment and receiver.

■ Connect the equipment into an outlet

on a circuit different from that to

which the receiver is connected.

■ Consult the dealer or an experi-

enced radio/TV technician for help.

If necessary, the user should consult the dealer

or an experienced radio/television technician

for additional suggestions. The user may find

the following booklet helpful: “Something About

Interference.”

This is available at FCC local regional offices.

Our company is not responsible for any radio or

television interference caused by unauthorized

modifications of this equipment or the substitu-

tion or attachment of connecting cables and

equipment other than those specified by our

company. The correction will be the responsibil-

ity of the user. Use only shielded data cables

with this system.

Intentional emitter per FCC Part 15

Low power, Radio LAN type devices (radio fre-

quency (RF) wireless communication devices),

operating in the 2.4 GHz Band, may be pres-

ent (embedded) in your notebook system. This

section is only applicable if these devices are

present. Refer to the system label to verify the

presence of wireless devices.
Wireless devices that may be in your system

are only qualified for use in the United States of

America if an FCC ID number is on the system

label.
The FCC has set a general guideline of 20 cm

(8 inches) separation between the device and

the body, for use of a wireless device near the

body (this does not include extremities). This

device should be used more than 20 cm (8

inches) from the body when wireless devices

are on. The power output of the wireless device

(or devices), which may be embedded in your

notebook, is well below the RF exposure limits

as set by the FCC. (This Statement is not appli-

cable to UMPC(Ultra Mobile PC) such as PDA,

Portable PC.)

Advertising
This manual is related to the following products: