Samsung NP-Q1-V000-SEA - Manual (Page 30)

30
Wireless devices that may be in your system are
only qualified for use in Canada if an Industry
Canada ID number is on the system label.
As a general guideline, a separation of 20 cm
(8 inches) between the wireless device and the
body, for use of a wireless device near the body
(this does not include extremities) is typical.
This device should be used more than 20 cm
(8 inches) from the body when wireless devices
are on.
The power output of the wireless device (or
devices), which may be embedded in your note-
book, is well below the RF exposure limits as set
by Industry Canada.
This transmitter must not be collocated or op-
erate in conjunction with any other antenna or
transmitter except the installed Bluetooth trans-
mitter.
Operation of this device is subject to the fol-
lowing two conditions: (1) This device may not
cause harmful interference, and (2) this device
must accept any interference received, including
interference that may cause undesired operation
of the device.
To prevent radio interference to li-
censed service, this device is intended
to be operated indoors and away from
windows to provide maximum shield-
ing. Equipment (or its transmit anten-
na) that is installed outdoors is subject
to licensing.
Wireless devices are not user service-
able. Do not modify them in any way.
Modification to a wireless device will
void the authorization to use it. Contact
manufacturer for service.
Telecommunications per DOC no-
tice (for products fitted with an IC-
compliant modem)
The Industry Canada label identifies certified
equipment. This certification means that the
equipment meets certain telecommunications
network protective, operation, and safety re-
quirements. The Department does not guar-
antee the equipment will operate to the users’
satisfaction.
Before installing this equipment, users should
make sure that it is permissible to be connected
to the facilities of the local telecommunications
company. The equipment must also be installed
using an acceptable method of connection. In
some cases, the inside wiring associated with a
single-line individual service may be extended
by means of a certified connector assembly. The
customer should be aware that compliance with
the above conditions may not prevent degrada-
tion of service in some situations.
Repairs to certified equipment should be made
by an authorized Canadian maintenance facility
designated by the supplier. Any repairs or altera-
tions made by the user to this equipment, or
equipment malfunctions, may give the telecom-
munications company cause to request the user
to disconnect the equipment.