Samsung NP-Q1-V000-SEA - Manual (Page 23)

23
The socket-outlet shall be installed near
the equipment and shall be easily acces-
sible.
Do not unplug the power cord out by
pulling the cable only.
Connect and Disconnect
the AC adapter
The power cord set (wall plug, cable and
AC adapter plug) you received with your
computer meets the requirements for use
in the country where you purchased your
equipment.
Power cord sets for use in other coun-
tries must meet the requirements of the
country where you use the computer.
For more information on power cord set
requirements, contact your authorized
dealer, reseller, or service provider.
Power Cord Requirements
General Requirements
The requirements listed below are ap-
plicable to all countries:
■ The length of the power cord set must be
at least 6.00 feet (1.8m) and a maximum
of 9.75 feet (3.0m).
■ All power cord sets must be approved by
an acceptable accredited agency respon-
sible for evaluation in the country where
the power cord set will be used.
■ The power cord set must have a minimum
current capacity of 7 A and a nominal
voltage rating of 125 or 250 volts AC, as
required by each country’s power system.
■ The appliance coupler must meet the
mechanical configuration of an EN 60
320/IEC 320 Standard Sheet C7 connec-
tor, for mating with appliance inlet on the
computer.