Samsung HT-H7730WM-ZA - Manual (Page 11)

11
- English
Connections
✎ If you place a speaker near your TV set, the screen color may be distorted because of the magnetic
field.
✎ Place the wireless receiver module at the rear of the listening position. If the wireless receiver module
is too close to the product, sound from the speakers may be disrupted because of interference.
✎ If you use a device such as a microwave oven, wireless LAN Card, Bluetooth device, or any other
device that uses the 2.4/5.8GHz frequencies near the product, sound from the speakers may be
disrupted because of interference.
✎ The maximum transmission distance from the product to the wireless receiver module is about 33
feet (10m), but may vary depending on your operating environment. If a steel-concrete wall or
metallic wall is between the product and the wireless receiver module, the system may not operate
at all, because the radio waves cannot penetrate metal.
✎ If the product doesn't make a wireless connection, you need to run an ID Set between the product
and wireless receiver module. With the product turned off, press and hold (mute) button on the
remote control for 5 seconds. Turn on the wireless receiver module. Then, press and hold the "Id
SET" button on the back of the wireless receiver module for 5 seconds, and then turn the product
on.
| CAUTION |
▶ If you want to install the speakers on the wall, fasten screws or nails (not provided) firmly to the wall
wherever you want to hang a speaker, and then, using the hole in the rear of each speaker, carefully
hang each speaker on a screw or nail.
▶ Do not let children play with or near the speakers. They could get hurt if a speaker falls.
▶ When connecting the speaker wires to the speakers, make sure that the polarity (+/ –) is correct.
▶ Keep the subwoofer speaker out of reach of children to prevent children from inserting their hands
or alien substances into the duct (hole) of the subwoofer speaker.
▶ Do not hang the subwoofer on the wall using the duct (hole).
▶ The wireless receiving antenna is built into the wireless receiver module. Keep it away from water
and moisture.
▶ For optimal listening performance, make sure that the area around the wireless receiver module
location is clear of any obstructions.
▶ In 2-CH mode, you will hear no sound from the wireless surround speakers.
Attaching the Toroidal Ferrite Core to the Power Cord of the Wireless
Receiver Module (SWA-6000)
If you attach a Toroidal ferrite core to the power cord of the
wireless receiver module, it will help prevent RF interference from
radio signals.
1. Pull the fixing tab of the Toroidal ferrite core to open it.
2. Make two loops in the wireless receiver module power cord.
3. Attach the Toroidal ferrite core to the wireless receiver
module's power cord as shown in the figure on the right, and
then close it by pressing it until it clicks.
~ Attach the ferrite core as close to the Wireless Receiver
Module as possible.