Samsung HT-H7730WM-ZA - Manual (Page 20)

20
- English
Settings
2) Set the Anynet+ (HdMI-CEC) feature to
On in both the TV and the product.
3) Search for and then select the product
in the TV's Anynet+ (HdMI-CEC) list. For
more exact instructions, see the Anynet+
section of the TV's user's manual.
Support
Remote Management
When activated, lets Samsung Call Center
agents diagnose and fix problems with the
product remotely. Requires an active Internet
connection. Remote Management service
might not be available in some countries.
Software Update
For more information about the Software
Update function, see "Upgrading Software" on
page 24.
Use Mode
Lets you set the Use Mode. If you are using the
home theater at home, always select Home
Use. Store demo is for retail display settings
only.
Contact Samsung
Provides contact information for assistance
with your product.
Reset
Reverts all settings to their defaults except for
the network and Smart Hub settings. Requires
that you enter your security PIN. Press and hold
the 123 button until the Num pad appears on the
screen. When the Num pad appears, select a
number using the ,.
button and then press
the Ok button. The default security PIN is 0000.
Network Setup
When you connect this product to a network,
you can use network based applications and
functions such as Smart Hub and BD-LIVE, and
upgrade the product's software through the
network connection. For more information about
accessing and using Internet services, see the
Network Services chapter of this manual on pages
41~48. Instructions for configuring the
network connection start below.
Configuring your Network Connection
If you didn't configure your network connection
during the initial settings procedure or you need
to reset the network connection, follow the
directions below.
Before you begin, contact your Internet Service
Provider to find out if your IP address is static or
dynamic. If it is dynamic, and you have a wired
or wireless network, we recommend using the
Automatic configuration procedures described
below.
If you are connecting to a wired network, connect
the product to your router using a LAN cable
before you start the configuration procedure.
To begin configuring your network connection,
follow these steps:
1. In the Home screen, select Settings, and then
press the Ok button.
2. Select Network, and then press the Ok
button.
3. Select Network Settings, and then press the
Ok button.
4. Go to the instructions for Wired networks
starting below or the instructions for Wireless
networks starting on page 21.
Wired Network
Ğ Wired – Automatic
After following Steps 1 to 3 above:
1. In the Network Settings screen, change
Network type to Wired. Then, select Connect
and press the Ok button. The product
detects the wired connection, verifies the
network connection, and then connects to
the network.
2. When it is done, highlight Ok, and then
press Ok button.