ATEN CN-6000 User Manual
Page 26
Filtering
M
There are a maximum of 100 filters allowed for each category (User IPs,
User MACs, and Administrator MACs).
M
To enable IP filtering for User Stations, Click to put a check mark in the IP
and/or MAC Filter enablecheckbox.
M
To add a filter, Click Add. A dialog box similar to the ones below appears (the
top example is for IP address filters; the bottom is for MAC address filters):
M
Specify the filter address in the dialog box, then Click OK.
M
Each IP filter can consist of a single address, or a range of addresses. For IP
filtering, a second dialog box similar to the one below appears:
To filter a single IP address, key in the same address as the start IP. To filter
a continuous range of addresses, key in the end number of the range.
2003-11-14
CN-6000 User Manual
18