ATEN CN-6000 - Manual (Page 30)

Customization
This configuration dialog allows the Administrator to set Timeout, Login failure, and
Working mode parameters.
An explanation of the Customization parameters is given in the table below:
Time out Control If the CN-6000 doesn’t receive any input from the computer that
currently has access to it for the amount of time specified here,
it ends the connection so it can be available for other users.
Login failure Login failures allowed, sets the number of consecutive failed
login attempts that are permitted from a remote computer.
Login failure timeout, sets the amount of time a remote
computer must wait before attempting to login again after it
has exceeded the number of allowed failures.
Working Mode If Stealth Mode is enabled, the CN-6000 cannot be pinged. If
Echo Mode is disabled, the CN-6000 will not show up in the
list of local CN-6000 units (see p. 10 and p. 30)
Reset on exit Placing a check here causes the CN-6000 to reset itself and
implement all the new changes when you log out. Wait
approximately 30 to 60 seconds before logging in following
the reset.
2003-11-14
CN-6000 User Manual
22