Samsung SEC-LC11ZKAVZW - Manual (Page 36)

32
Radio Frequency (RF) Energy
Understanding How Your Samsung Mobile Hotspot
Operates
Your device functions as a radio transmitter and receiver. When it
is turned on, it receives and transmits radio frequency (RF)
signals.
Knowing Radio Frequency Safety
The design of your device complies with updated NCRP
standards described below:
In 1991–92, the Institute of Electrical and Electronics Engineers
(IEEE) and the American National Standards Institute (ANSI) joined
in updating ANSI’s 1982 standard for safety levels with respect to
human exposure to RF signals. More than 120 scientists,
engineers and physicians from universities, government health
agencies and industries developed this updated standard after
reviewing the available body of research.
In 1993, the Federal Communications Commission (FCC) adopted
this updated standard in a regulation. In August 1996, the FCC
adopted a hybrid standard consisting of the existing ANSI/IEEE
standard and the guidelines published by the National Council of
Radiation Protection and Measurements (NCRP).
For more information about RF exposure, visit the FCC Web site
at
www.fcc.gov .
FCC Radio Frequency Emission
This device meets the FCC Radio Frequency Emission Guidelines.
FCC ID number: A3LSCHLC11.
FCC Statement
This device has been tested and complies with the specifications
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used according to the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which is found by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.