AGFA Scanner - Manual (Page 19)

Chapter 2 — Installing the scanner 19
If your SnapScan will be connected to your Apple Macintosh together with other
SCSI devices:
■ If you install the scanner at the end of your SCSI chain:
1. Remove the terminator from the last device in the SCSI chain.
2. Connect the 50-pin end of the SCSI cable to the connector that has become available on this
device.
3. Place the terminator on the free 50-pin connector of the scanner.
4. Connect the 25-pin end of the SCSI cable to the free connector of the scanner.
5. Snap the diamond shaped wire clips into the clip brackets to secure the connection.
In case of problems, refer to Appendix C, “Troubleshooting” .