AGFA Scanner - Manual (Page 25)

Chapter 2 — Installing the scanner 25
If you are using another card:
1. Open the Adaptec SCSI interrogator.
A dialog box appears with a list of the SCSI ID numbers that are free in your PC.
Your PC always occupies ID 7. If your PC is equipped with 2 SCSI-busses, the Adapter menu
allows you to switch busses.
2. Check if SCSI ID number 2 is free.
Your SnapScan is preset to ID 2.
n If SCSI ID number 2 is free, close the Adaptec SCSI interrogator.
n If SCSI ID number 2 is already assigned, you need to set the scanner to a free SCSI ID number:
1. Make sure your scanner is switched off and is disconnected from your computer.
2. Decide on an unassigned SCSI ID number.
3. Push the button above or underneath the SCSI ID number at the rear of the scanner until
you see the number you want.
Push the button above the SCSI ID number to decrease the number, push the button
underneath the SCSI ID number to increase the number.
4. Close the Adaptec SCSI interrogator.