Allied Telesis AT-GS950/48 - Manual (Page 115)

AT-GS950/48 Web Interface User Guide
115
Group Status
To display the LACP Group Status, perform the following procedure:
1. Select the Bridge folder.
The Bridge folder expands.
2. From the Bridge folder, select the Trunk Config folder.
The Trunk Config folder expands.
3. From the Trunk Config folder, select LACP Group Status.
The LACP Group Status Page is displayed. See Figure 37 for a partial
view of this page.
Figure 37. LACP Group Status Page
Note
Go to “Create a Port Trunk” on page 103 to directly change the
parameters on this page:
The System Priority is a pre-assigned value that you cannot alter.
This value applies to the switch. See “System Priority” on page 111.
The System ID is a MAC address value assigned to the individual
switch. You cannot change this value.
Group 1 to 8 indicates the ID number of the trunk (aggregation group).