Allied Telesis AT-GS950/48 - Manual (Page 96)

Chapter 5: Multiple Spanning Tree Protocol
96
MST Port Settings
To configure the MST port settings, perform the following procedure:
1. From the main menu on the left side of the page, select Bridge.
The Bridge folder expands.
2. From the Bridge folder, select the Spanning Tree folder.
The Spanning Tree folder expands.
3. From the Spanning Tree folder, select MST Port Settings.
The MST Port Settings Page is displayed. See Figure 33.
Figure 33. MST Port Settings Page
You may choose a port and configure its MSTP parameters on this
page. The following information is displayed:
Port - You can select one of the ports on the AT-GS950/48 switch
using the Port drop-down menu.
MSTI ID - Indicates the MSTP Instance associated with this port.
Designated Bridge - Indicates the bridge providing the least-cost
path to the root bridge from a network segment.
Internal Path Cost - Indicates the operating cost of a port when it
is connected to a bridge in the same MSTP region.
Admin Path Cost - Specifies the cost of a port to the root.
Priority - Select the spanning tree port priority using the Priority
drop-down menu.
State - Indicates the port state:
Enabled - Allows the port to forward packets.
Disabled - Does not allows the port to forward packets.