Allied Telesis AT-8100 Series - Manual (Page 1056)

Chapter 70: MAC Address-based Port Security Commands
1056
SWITCHPORT PORT-SECURITY AGING
Syntax
switchport port-security aging
Parameters
None
Mode
Port Interface mode
Description
Use this command to configure the ports to add the source MAC
addresses as dynamic MAC address in the MAC address table. Ports that
learn their maximum numbers of addresses can learn new addresses as
inactive addresses are deleted from the table.
Confirmation Command
“SHOW PORT-SECURITY INTERFACE” on page 1050
Example
This example sets port 2 to store its learned MAC addresses as dynamic
addresses in the MAC address table:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# switchport port-security aging