No ip rip authentication mode, No ip rip authentication mode 3 – Allied Telesis AT-8100 Series User Manual
Page 1883
Advertising
AT-8100 Switch Command Line User’s Guide
1883
NO IP RIP AUTHENTICATION MODE
Syntax
no ip rip authentication mode
Parameters
None
Mode
VLAN Interface mode
Description
Use this command to restore the default value of plain-text authentication
mode.
Confirmation Command
“SHOW RUNNING-CONFIG” on page 170
Example
The following example restores the default value of plain-text
authentication mode for the routing interface in VLAN 2:
awplus> enable
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# no ip rip authentication mode
Advertising