Allied Telesis AlliedView-EMS 3.10 DEVICE MANAGEMENT - Manual (Page 337)

AlliedView™-EMS 3.10 Device Management Guide Page 337 of 367
Traffic Priority
Displays the system base priority.
Note - Setting the Routing Limit parameter under Bridge -> Routing Limit to a value
other than 'none' will cause the Base Priority parameter to be set to 0.
Routing Limit
Displays the routing limit.
Note - When the Routing Limit parameter is set to a value other than 'none', the
value '???(0)(???(0))' may sometimes be displayed for this parameter.
QoS Info
Displays Differentiated Service Code Point (DSCP) entries and its QoS priority level.
IGMP Menu
From the IGMP menu, you can view and edit information related to Internet Group
Management Protocol (IGMP).
Leave Time
Displays RTC status information including current time, offset, last update, and last
delta.
Note - Valid MIB Set values for the Leave Time parameter are in the range [0-25]
inclusive. Attempting to set this parameter to a value outside the valid range will not
result in an error but the new value will not be applied.
Note - AT-RG634A: Valid MIB Set values for the Leave Time parameter are in the
range [0-65535] inclusive. Setting this parameter to a valid or invalid value always
results in the error message: "The error occurred with 'Set' operation. Error:
commit Failed."
Note - AT-RG644B: When configuring the IGMP Leave Time parameter, the current
firmware version is able to configure the parameter successfully for the CLI but not
for SNMP. As a result, Device Manager will always display the value 0.
VLAN Info
Displays the VLAN table.
Group Info
Displays a list of all group multicast address.
Server Info
Displays a list of all multicast servers.