APW Wyott M2000 - Manual (Page 10)

10
Wipe down all external stainless steel surfaces with a damp cloth.
RE-ASSEMBLY
Before assembling the conveyor check the following: Fasteners on the Conveyor Assembly
hardware should be tight with no signs of wear. Conveyor shaft gear and the Motor Shaft gear are
tight. Hanger Bracket screws are tight and the brackets have not shifted during use.
TROUBLESHOOTING GUIDE
Always ask and check the following:
1. Is the unit connected to a live power source of the proper voltage?
2. Check the circuit breaker.
3. Is power switch “ON” and pilot light glowing?
4. Check the rating label. Is the unit connected to the correct power source?
If the above checks out, and you still have problems, call an APW Wyott
authorized service agent. APW SERVICE HOT LINE 1-800-733-2203
PROBLEM CAUSE SOLUTION
Buns won’t toast Wrong temperature setting
Excessive cupping of bun
surface Increase temperature setting
and allow two cycles to warm
up.
Buns are stale, use fresher
buns
Buns toast unevenly Excessive cupping of bun
surface
Conveyor pressure too light Buns are stale, use fresher
buns
Adjust conveyor tension
Buns stick to grill Teflon sheet worn.
Doughy buns or excessive
sugar and moisture, plus grill
temperature too high.
Build up on Grill Surface Replace Teflon sheet
Reduce grill temperature
Allow buns to age.
Clean Grill per instructions
No power No power at the wall
receptacle
Power cord disconnected
Main switch
Check circuit breaker or fuse
Check plug at receptacle
Check that switch is “ON” and
operative
Conveyor will not turn (Motor
turns) Drive gears not engaged
Gear set screws not tight
Check gear alignment and
engagement
Check screws and tighten if
required