APW Wyott M2000 - Manual (Page 6)

6
Never spray water on the toaster or controls. Damage to the toaster as well as injury could
occur. Severe injury and burns may occur if you do not follow this instruction sheet.
DISASSEMBLY
Turn off main power switch and conveyor switch. Disconnect the power supply cord from the wall
outlet. The toaster will be hot when turned off. Allow the toaster to cool for at least 15 – 30 minutes
before handling. USE CAUTION during disassembly and cleaning. Grasp the left side of the Butter
Roller Shaft. Lift up and to the left to remove from drive assembly. Remove the Butter Pan. Remove
the Top and Bottom Front Panels.
NOTE: Do not use any chloride or chlorine -based products to clean or rinse toaster or toaster
parts.
Daily Parts Cleaning:
The Butter Roller, Butter Pan, Feeder, and Top and Bottom Front Panel can be placed in a
dishwasher or sink and washed with detergent and warm water.
Daily Conveyor Cleaning:
Conveyor may be hot and is heavy, use caution when lifting and removing. Remove the
conveyor assembly by gripping the two handles at the top and lifting forward until it clears the gears.
Lift it up and out gently placing it in a sink with the drain stopped, or in a suitable container to soak
over night. Conveyor can be placed in the sink or container while warm. Use caution when
handling a hot conveyor. The soak solution is a mix of 10 parts hot water (120ºF or more) to 1 part
(minimum) “INSIDE OUT” brand 3-IN-1. Fill the sink or suitable container with the solution, to
completely cover the conveyor by approximately one inch. Allow the conveyor to soak in the
solution over night. Remove the conveyor from the solution. Use a stiff non- metal brush or plastic
pad to remove residual bun oil. Insure the chains are clean and free from debris. Use a brush to
remove any soil or debris remaining on the chain. Rinse conveyor with plain hot water and allow to
drain. Lubricate both chains thoroughly with vegetable oil. Bun oil may be used if it contains no
animal fats, salts or dairy products. Note: Chain Lubrication is critical to chain life. Oil the chain
daily. Gently replace conveyor into toaster. Discard used soak solution. Clean and sanitize sink
or container after over night use!
Replace all removed toaster parts. Plug power supply cord into wall outlet. Turn main power switch
on. Turn conveyor switch on.
Severely baked on oils as shown in Figure 3 require the conveyor to be cleaned using the
‘emergency one-time’ boil instructions below to clean.
Figure 3