APW Wyott M2000 - Manual (Page 2)

2
SAFETY PRECAUTIONS
APW Wyott toasters are designed, built, and sold for commercial use and should be operated by trained personnel
only. Clearly post all CAUTIONS, WARNINGS and operating instructions near each unit to insure proper
operation and to reduce the chance of personal injury and/or equipment damage.
Always disconnect power before cleaning or servicing the toaster. Surfaces will remain hot after power has been
turned off, allow unit to cool before cleaning or servicing. Never clean the toaster by immersing it in water. The
toaster is not protected against water jets; DO NOT CLEAN TOASTER WITH A WATER JET. Always clean
equipment before first use.
Operating toaster without legs will void the warranty. Insure all accessories and exterior panels are properly
installed and adjusted before applying power and operating.
GENERAL INFORMATION
Check the rating label for your model designation and electrical rating. Rating Label is located on the bottom front
of the control panel.
Overall dimensions with feeder: 23.5"(59.7cm) W x 25.9"(65.8cm) H x 17.5"(44.5cm) D
Electrical ratings:
M2KA: 208VAC, 2880W, 13.8A 60Hz
M2KH: 240VAC, 3840W, 16A 60Hz
Cordset Configuration:
208/250V: NEMA 6-20P Plug, 4 foot, 3 wire grounded cord.
If the supply cord is damaged, the manufacturer or an authorized service agent or a similarly qualified person must
replace it to avoid a hazard or warranty.
Shipping Weight:
94 lbs (42.7 Kg)
INSTALLATION
1. Examine carton for damage. The freight carrier has assumed responsibility for its safe transit and delivery. If
equipment is received damaged, either apparent or concealed, a claim must be made with delivering carrier.
a. Apparent damage or loss must be noted on the freight bill at the time of delivery. The carrier
representative (Driver) must sign the freight bill. If this is not done, the carrier may refuse the claim.
The carrier can supply the necessary forms.
b. Concealed damage or loss if not apparent until after the toaster is removed from carton, a request
for inspection must be made to the carrier within 15 days. The carrier should arrange an inspection. Be
sure to save all contents and packaging material.
2. Verify Parts
After removing unit from the shipping carton, unwrapping loose parts and remove any packing tape, plastic wrap
and nylon tie-down. Verify the following parts: