APW Wyott M2000 - Manual (Page 5)

5
LOCATION
Place the toaster on a flat surface. This toaster is tested and approved for zero clearances against
non-heated surfaces. Locate the toaster near a wall receptacle of the proper configuration. DO NOT
USE AN EXTENSION CORD. Plug the power cord into an outlet (receptacle) of the specified
voltage on the rating label. Outlets must be properly grounded.
OPERATING INSTRUCTIONS
Choose Dry or Wet operation.
1. Dry operation. (no oil) Insure Teflon sheet, 86298 is properly installed.
a. Turn Main Power Switch on. Set Temperature Control knob to desired temperature.
Allow Pilot Light to cycle at least two times (on/off). When the light is on, the grill is
heating. Heat up time is about 15-20 minutes.
b. Turn on motor switch. Conveyor should start to turn.
c. Place bun halves on feeder cut side down (facing grill surface). Toast time is
approximately 22 sec. depending on bun height and diameter. Increase or decrease
temperature setting to achieve desired brownness and temperature.
2. Wet operation. (using oil) Apply a light coating of oil to grill surface. (Fry oil can be used)
When toasting using oil, any high-quality cooking oil may be used with this toaster (do not use
oils that contain dairy products such as butter). The Teflon sheet may be used, but it is not
required. Fill the Butter Pan 2/3 full of warmed cooking oil. The oil should spread evenly over
the surface of the roller.
a. Turn Main Power Switch on. Set Temperature Control knob to desired temperature.
Allow Pilot Light to cycle at least two times (on/off). When the light is on, the grill is
heating. Heat up time is about 15-20 minutes.
b. Turn on motor switch. Conveyor should start to turn.
c. Holding the bun half in the palm of the hand, slap the face (cut side) of the bun on the
turning Butter Roller surface.
d. Place bun halves on feeder cut side down (facing grill surface). Try several buns to
determine the correct pressure and time to achieve the desired browning and temperature
of bun. Using too little oil will cause the bun surface to be cool and uneven in color. It
will also cause the bun to stick to the grill. Using too much oil will give the bun a yellow
un-toasted look. Toast time is approximately 22 sec. depending on bun height and
diameter. Increase or decrease the temperature setting to achieve desired brownness and
temperature.
NOTE: Should the temperature setting be changed, allow several cycles for the grill plate to
adjust. Once the desired setting has been achieved, note the temperature and keep it set there.
CLEANING
WARNING: Make sure the toaster is in the off position and has been off at least 15 – 30
minutes. Do not attempt this cleaning procedure if the toaster components are too hot to touch.