APW Wyott M2000 - Manual (Page 3)

3
Item Packaging Qty
Legs In plastic bag 4
Feeder/Bun Chute Wrapped, loose in top of carton 1
Conveyor In individual carton 1
Instruction Manual Loose in carton 1
Teflon Sheet Kit (optional) Loose in carton Optional
NOTE: PRIOR TO INITIAL START-UP, ALL REMOVABLE PARTS AND THE GRILL SURFACE SHOULD
BE CLEANED WITH WARM SOAPY WATER TO REMOVE MANUFACTURING OILS, THEN RINSED
AND DRIED THOROUGHLY. Apply oil (vegetable oil) to the conveyor chain after washing. (Bun oil can be used
if it contains no animal fats, salts or dairy products.)
3. Assemble Legs
Lay the toaster on its back and install the four adjustable legs into the threaded holes on the bottom of the toaster
sides. Hand tighten the legs by gripping the black shank and turning until it is seated firmly against the bottom of
the toaster. Set the toaster upright on a flat surface. Unscrewing the lower, chrome insert of each leg levels the unit.
Flats are provided on two sides of the insert to allow use of a wrench. “Precise” leveling is not required for proper
operation.
Figure 1. M2000 Assembly Drawing
??
??