Allied Telesis AT-S70 - Manual (Page 153)

AT-S70 Management Software User’s Guide
153
The following prompt is displayed:
Enter User (Security) Name:
6. Enter the User Name of the User Table you want to modify.
The following prompt is displayed:
Enter Authentication Protocol [M-MD5, S-SHA, N-None]:
7. Enter one of the following:
M-MD5
This value represents the MD5 authentication protocol. With this
selection, users (SNMP entities) are authenticated with the MD5
authentication protocol after a message is received. This algorithm
generates the message digest. The user is authenticated when the
authentication protocol checks the message digest. With the MD5
selection, you can configure a Privacy Protocol.
S-SHA
This value represents the SHA authentication protocol. With this
selection, users are authenticated with the SHA authentication protocol
after a message is received. This algorithm generates the message
digest. The user is authenticated when the authentication protocol
checks the message digest. With the SHA selection, you can configure
a Privacy Protocol.
N-None
This value represents no authentication protocol. When messages are
received, users are not authenticated. With the None selection, you
cannot configure a Privacy Protocol.
If you select None, proceed to step 10.
If you select MD5 or SHA, the following prompt is displayed:
Enter Authentication Password:
8. Enter an authentication password (with a minimum of 8 and a
maximum of 32 alphanumeric characters) and press Return.
The following prompt is displayed:
Re-Enter Authentication Password:
9. Re-enter the password.
10. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.