Allied Telesis AT-S70 - Manual (Page 202)

Chapter 9: SNMPv3
202
V-Volatile
Select this storage type if you do not want the ability to save an entry in
the SNMPv3 Notify Table to the configuration file.
N-NonVolatile
Select this storage type if you want the ability to save an entry in the
SNMPv3 Notify Table to the configuration file. Allied Telesis
recommends this storage type.
8. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
9. From the System Configuration Menu, select Save Configuration
File.
Displaying the
SNMPv3 Notify
Table Menu
This section describes how to display the Display SNMPv3 Notify Table
menu. For information about the SNMPv3 Notify Table parameters, see
“Creating an SNMPv3 Notify Table Entry” on page 195.
To display the Display SNMPv3 Notify Table menu, perform the following
procedure.
1. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
2. From the System Configuration menu, select SNMPv3
Configurations.
The SNMPv3 Configurations menu is displayed, as shown in Figure 61
on page 147.
3. From the SNMPv3 Configurations menu, select Configure SNMPv3
Notify Table.
The Configure SNMPv3 Notify Table menu is displayed, as shown in
Figure 74 on page 196.
4. From the Configure SNMPv3 User Table menu, select Display
SNMPv3 Table Entry.