Allied Telesis AT-S70 - Manual (Page 35)

AT-S70 Management Software User’s Guide
35
Note
When you enable the DHCP client software, the chassis
immediately begins to query the network for a DHCP server. The
chassis continues to query the network for its IP configuration until it
receives a response.
Any static IP address, subnet mask, and gateway address assigned
to the chassis are deleted from the Administration menu and
replaced with the values the chassis receives from DHCP server. if
you later disable DHCP, these values are returned to their default
settings, as shown in Appendix A, “AT-S70 Default Settings” on
page 261.
Configuring the
Management IP
Addresses
You can specify the IP addresses of up to four network management
workstations to receive SNMP traps from the system.
Note
For a list of actions that generate SNMP traps, refer to “SNMP
Traps” on page 92.
To configure the management IP addresses, perform the following
procedure:
1. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 3 on
page 29.
2. From the System Configuration Menu, select IP Parameters.
The IP Parameters Menu is displayed, as shown in Figure 4 on page
32.
3. Adjust the following parameters as necessary:
Manager address(es)
This parameter specifies the IP addresses of up to four network
management workstations to receive SNMP traps from the chassis.
This is optional.
4. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 3 on
page 29.
5. From the System Configuration Menu, select Save Configuration
File.