Allied Telesis AT-FS238b/2 User Manual
Page 41
AT-FS238a/x and AT-FS238b/x Series Installation Guide
31
Warning
"Safety Hazard"- Check to see if there are any exposed copper strands
coming from the installed wires. When this installation is done correctly
there should be no exposed copper wire strands extending from the
terminal block. Any exposed wiring can conduct harmful levels of
electricity to persons touching the wires.
19
10. With the wires securely connected to both the input power connector in
the rear of the unit and the terminal block on the power adapter, plug the
power adapter to the power outlet. (Refer to “Technical Specifications” on
page 37 for power requirements.)
11. Verify that the PWR LED on the front of the unit is green. If the PWR
LED is OFF, refer to “Troubleshooting” on page 33.
12. Perform Step 7 through Step 10 on page 25 to complete the installation.