Blodgett 40GS-KLS Series - Manual (Page 6)

4 OM-40GS-KLS
Blodgett 40GS-KLS steam kettles are stainless steel, floor mounted kettles with a self-
contained steam source heated by gas. A closed steam jacket covers the lower 2/3 of
the kettle. Heat from the gas burner boils water in the jacket to produce steam under
pressure. To ignite the burners, the kettle uses electronic spark ignition.
The kettles are stationary (non-tilting). Liquids can be removed through the tangent
draw-off valve.
Exposed surfaces are stainless steel. Insulated sheathing protects the kettle body, and
a housing encloses the controls. Three tubular legs support the unit. Bullet feet adjust to
level the kettle.
A one piece dome cover is hinged to the kettle. Covers for 40 gallon kettles are supplied
with counterbalancing spring actuators to hold the covers in the fully open or closed
position.
Controls provided include the ON/OFF switch, to control electric power for the unit,
and the thermostat, to set the cooking temperature. The automatic controls and a brief
description of each are as follows.
1. Gas pressure regulator: Protects the unit from high pressure in the gas supply line.
2. Automatic gas valves: Allow gas into the burners as needed.
3. Pressure limit switch: Turns off the burner when jacket pressure reaches 27 PSI.
Lights the burner when pressure drops to 22 PSI.
4. Safety valve: Lets steam out of the jacket if the steam pressure exceeds 30 PSI.
5. Low-water cutoff: Turns off the burner if the water level in the jacket gets too low
for safe operation.
Instruments also are provided to show what is happening inside the unit. These are:
1. Water level sight glass: Indicates whether there is enough water in the steam
jacket.
2. Pressure/vacuum gauge: Shows steam pressure, and whether too much air has
entered the jacket.
3. Heating indicator light: Indicates that the kettle is being heated.
4. Power on indicator light: Glows when the unit is turned on.
5. Low water indicator light: Lights to show that jacket water needs to be replenished.
The kettle body is welded into one piece and has a rim reinforced by a rectangular bar.
The interior and exterior of the kettle is polished to a 180 emery grit finish. The unit is
ASME shop inspected and registered with the National Board for working pressures up
to 30 PSI.
The standard 2 inch tangent draw-off is a 316 stainless steel, compression disc valve. A
removable strainer with ¼ inch holes keeps pieces of product from entering the draw-off
during cooking.
The jacket is filled at the factory with water containing rust inhibitors. The kettle can
operate at steam pressures up to 30 PSI, which provide temperatures of 150ºF (65ºC) to
approximately 250ºF (121ºC). This range allows warming, simmering, boiling, or braising.
Equipment Description
MODEL Ignition
FIRING RATE, BTU/HR
Natural
Gas
Propane
Gas
40GS-KLS Spark 115,000 115,000