Spektrum SPM3100 DX3R - Manual (Page 11)

11 SPEKTRUM DX3R PROGRAMMING GUIDE
6. Carefully pull out the grip plate that contains
buttons D, E and F. Use a Phillips screwdriver
remove the PC board and backplate from the grip
plate. Note the positions of the three buttons.
7. Transfer the three buttons (D,E and F) to the other
“handed” grip plate noting that the buttons fit in
a specific direction such that they fit the external
contour of the grip plate.
8. Carefully screw the PC board and backplate
in place and test that all buttons are
depressing properly.
9. Place both grip plates in place and fasten them
using four Phillips screws (two per side).
10. Push the steering wheel connector through the
transmitter case to the opposite side.
11. Select the opposite “handed” steering shell and
pass the steering wheel mechanism connector
through the hole in the shell.