Spektrum SPM3100 DX3R - Manual (Page 22)

22 SPEKTRUM DX3R PROGRAMMING GUIDE
bInd
User Name
01: Model 01
Bind
BIND
Place the RX
into bind
mode first.
≤
Binding is the process of teaching the receiver the
specific transmitter’s code called GUID (Globally
Unique Identifier) and store failsafe values . When a
receiver is bound to a transmitter/ model memory,
the receiver will only respond to that specific
transmitter/ model memory (see ModelMatch
below). It’s also important to understand that during
the binding process the transmitter is learning the
type of receiver that it’s being bound to, and the
transmitter configures itself to transmit in DSM1 or
DSM2 protocol depending on the type of receiver
that it’s being bound to. Note that the DX3R stores
this information for each model memory and recalls
the proper protocol when that model is selected. See
ModelMatch below.
Note: If a receiver is not bound to a specific
model memory, it will not operate.
ModelMaTCh
The DX3R features patented ModelMatch technology
that prevents operating a model using the wrong
model memory. During the binding process, the
receiver actually stores the code that is assigned
to the specific model that is currently selected in
the transmitter. For example: if the model that is
selected in the transmitter is model #3, when a
receiver is bound to that transmitter, the receiver will
only operate when model #3 is selected. If another
model memory is selected (model #5 for example)
the receiver will not connect. If model three is
again selected in the transmitter, the receiver bound
to model #3 will connect. ModelMatch prevents
operating a model using the wrong model memory.
bIndIng a reCeIver
Note: The SR3100 features DSM2 second-
generation technology and is only compatible
with transmitters that utilize DSM2 protocol
(like the DX3R). DSM1 transmitters will not
use the SR3100 receiver.
1. With the receiver off insert the bind plug into the Batt/
Bind port in the receiver.
2. Power the receiver. The amber LED will flash
continuously, indicating that the receiver is in
bind mode.
3. Turn on the transmitter and make sure the transmitter is
in the desired model number that you intend to use.
4. Press the rolling selector to access the List screen.
5. Rotate the roller to highlight the Bind screen and press
the roller to access this screen.