Spektrum SPM3100 DX3R - Manual (Page 25)

25 SPEKTRUM DX3R PROGRAMMING GUIDE
MIxIng
The mixing function allows any of the channels
(steering, throttle and Aux.) to be mixed to any
channel. Two mixes are available, Mix A and Mix
B. Both mixes function identically. Typically this is
used for dual steering servos in giant-scale trucks or
for dual throttles in dual engine boats. The primary
or controlling channel is called the master while the
channel that is mixed to is called the slave. The slave
channel follows the movement of the master channel
based on the mixing value that is programmed.
Negative values cause the slave to move in the
opposite direction. Note that the trim is active for
both the master and slave channels.
Mix A
User Name
Master
Inhibit
Slave
Auxilliary
Value
+0% +0%
01: Model 01
≤
To aCCess The MIx funCTIon:
In the List screen use the roller to highlight the
Mixing function.
Press the roller to access the Mixing function. The
Mixing screen will then appear.
Use the roller to select the desired Mix that you wish
to adjust, Mix A or Mix B.
Press the roller to highlight that mix and the
surrounding box will flash, then rotate the roller to
access that mix function.
Use the roller to highlight the master or slave
channels, then press the roller to access master
or slave.
Use the roller to highlight Value, then press the
roller. Adjust the mix values by rotating the roller.
Independent values can be adjusted by holding the
master channel input (i.e. steering wheel) in the
desired direction and scrolling the roller.
To return to the Main screen press and hold the
roller for more than three seconds.
Mixing values and their proportions can be observed
in the Monitor screen on page 28.