Spektrum SPM3100 DX3R - Manual (Page 8)

8 SPEKTRUM DX3R PROGRAMMING GUIDE
bIndIng a reCeIver
Note: The SR3100 features DSM2 second-
generation technology and is only compatible
with transmitters that utilize DSM2 protocol (Like
the DX3R) DSM1 transmitters will not operate the
SR3100 receiver.
1. With the receiver off, insert the bind plug into the Batt/
Bind port in the receiver.
2. Power the receiver. The amber LED will flash
continuously, indicating that the receiver is in bind
mode.
3. Turn on the transmitter and make sure the transmitter is
in the desired model number that you intend to use.
4. Press the rolling selector to access the List screen.
5. Rotate the roller to highlight the Bind screen and press
the roller to access this screen.
User Name
01: Model 01
Bind
BIND
Place the RX
into bind
mode first.
≤
6. Rotate the roller to highlight BIND.
7. With the steering wheel, throttle stick and Aux channel
(if applicable) in the desired preset failsafe positions,
press the roller to initiate the bind process and to store
the failsafe positions. BIND will flash for a few seconds
then the transmitter will beep, indicating the process
is complete. The LED on the receiver should now be
solid, indicating a successful bind has taken place.
8. Remove the bind plug and store it in a
convenient place.
Note: The only time it’s necessary to do a
rebind is if different failsafe positions are
desired or if the receiver is to be bound to a
different model memory.
Note: Some Spektrum receivers like the
AR3000 use a bind button rather than a bind
plug. The binding process is the same with
this receiver, however, instead of inserting the
plug before powering up the receiver, press
and hold the bind button while powering up
the receiver to enter the bind mode.